Latitude – Section 5 – The Hochiki Training Academy

5.6 – Vision Repeater – Main Board (contd)

admin2026-03-12T11:33:47+00:00

This image shows the Vision Repeater's Main Board with the Network Board fitted. The main components here are: 24 VDC

5.6 – Vision Repeater – Main Board (contd)admin2026-03-12T11:33:47+00:00

admin2026-03-12T11:33:24+00:00

The Vision Repeater's Main Board features the following components: Additional SD Card Memory Slot Repeater Buzzer Processor Reset Button General

5.5 – Vision Repeater – Main Boardadmin2026-03-12T11:33:24+00:00

admin2026-03-12T11:32:59+00:00

The Latitude Vision Repeater Unit is fully programmable as an interactive Fire Alarm Repeater. Three mounting options: Surface, Semi-Flush and

5.4 – Vision Repeateradmin2026-03-12T11:32:59+00:00

admin2026-03-12T11:32:30+00:00

The Network Board comes with a set of factory-fitted 0 Ohm resistors. As the network terminations must be made to

5.3 – Network Data Terminations – contdadmin2026-03-12T11:32:30+00:00

admin2026-03-12T11:32:02+00:00

Networking panels and repeaters must be with two-core cables (not four-core). Panels are connected in a fault tolerant loop A

5.2 – Network Data Terminations – Wiringadmin2026-03-12T11:32:02+00:00

admin2026-03-12T11:31:32+00:00

The Latitude panel uses the RS485 data connection for networking. By adding a Network Board, up to 127 Latitude panels

5.1 – Network Data Terminationsadmin2026-03-12T11:31:32+00:00