Ekho Advanced – Section 3 – Page 2 – The Hochiki Training Academy

Adding an Ekho Device via Ekho Configurator Software

Paul2025-08-12T10:52:39+00:00

Note: Before making any changes in this way, follow the steps described at the start of Section 2 of this

Adding an Ekho Device via Ekho Configurator SoftwarePaul2025-08-12T10:52:39+00:00

Paul2025-08-12T09:41:30+00:00

You can manually change the loop address of a device in the Ekho Configurator Software. From the configuration menu, right-click

Changing Loop Address via Ekho Configurator SoftwarePaul2025-08-12T09:41:30+00:00

Paul2025-08-18T12:33:09+00:00

When you make changes to device properties you need to synchronise those changes between the software and the physical field

Hardware and Ekho Configurator Software SynchronisationPaul2025-08-18T12:33:09+00:00

Paul2025-08-12T09:39:08+00:00

You can inspect the entire Ekho system via the Ekho Configurator Software Firstly, connect the TRH to the PC using

Read System from Hardware via Ekho Configurator SoftwarePaul2025-08-12T09:39:08+00:00

Paul2025-08-12T09:39:49+00:00

The system's device loop addresses can also be displayed in the loop address table within the Ekho Configurator Software. From

Checking Radio Addresses via Ekho Configurator SoftwarePaul2025-08-12T09:39:49+00:00